Figure7-16 : Pm-3114 Setting Page - ICP DAS USA PMC-523 Series User Manual

ICP DAS PMC-523x/PMC-224x/PMD Series User Manual
 Main Power Meter: When the "Set as main power meter" is
 CT/Phase Nickname: For user to define nicknames for each CT
After all settings are completed, click "OK" button to return to the
Power Meter List.
 The Single-Phase Modbus RTU Power Meter Setting page is shown
as follow (using PM-3114 as an example):
The settings are as follow:
 For the settings of Nickname, Description, Address, Scan Rate,
seconds.
selected, this power meter will be set as main power meter and
the power data of this meter will be displayed on the Main
Power Meter area on the "Power Data Overview" page.
(or phase), this nickname will be displayed on the "Power
Meter Information" and "Rule Setting" pages. For three-phase
power meter, the user could give nicknames to the Phase A/B/C.
Figure7-16 :
Polling Timeout, Retry Interval and Main Power Meter, please
refer to "Three-Phase Modbus RTU Power Meter Setting"
section.
PM-3114 Setting Page
83