Table of Contents
Advertisement
ICP DAS PMC-523x/PMC-224x/PMD Series User Manual
Power Data logger files, I/O Power Data logger files and User-Defined Data
logger files can be upload to remote FTP server of the manage center via
FTP protocol. The FTP Upload Setting page allows to set up parameters for
FTP Upload, the setting page is shown as below:
Follow the steps below:
i In the "Function Status", check "Enable" to enable the FTP Upload
function.
In the "Remote FTP Server" section, input Address, Port, ID, Password
ii
and Path
iii The user could test if the FTP settings are correct in the "Remote FTP
Server Setting Test" section. After clicking "Send", the system will
create a folder on the remote FTP server and will generate a test file
under this folder.
iv In the "Data Log Upload Function" section, select the data log
user would like to upload. The data log type could be "Power Data
Log", "I/O Data Log" or "User-Defined Data Log". And then select the
Frequency from the dropdown list of the "Frequency" field. The
Frequency can be set as: 5 mins, 15 mins, 1 hour, 3 hours, 6 hours, 12
hours, or 24 hours. The default setting will be 1 hour.
v
In the Event Log Upload Function section, if the user would like to
enable the Upload Event Log function, check "Upload Event Log"
field. And then select the Frequency from the dropdown list of the
Figure8-4 :
FTP Upload Setting Page
type
125
Advertisement
Table of Contents
