Modbus Rtu Module Setting; Figure7-41 : M-7000 Ao Channel Setting Page - ICP DAS USA PMC-523 Series User Manual

ICP DAS PMC-523x/PMC-224x/PMD Series User Manual
 The AO channel setting for M-7000 module
The M-7000 module AO channel setting interface is shown as
below (using M-7024 as an example)
The settings are as below:
 Nickname：For user to define nickname for each I/O channel,
 Type: Select the output signal type of the AO channel from the
After all settings are completed, click "OK" button to save the
changes and return to Modbus RTU Module List.
Please note: To set up the Power On value of the AO channels on
M-7000 modules, please use DCON Utility to set the value.
7.3.6

Modbus RTU Module Setting

PMC/PMD allows connections to modules that support Modbus RTU
Slave protocol for offering I/O interface function. Through Modbus
RTU protocol, it enables to read or write 4 types of Modbus data (Coil
Output, Discrete Input, Input Register and Holding Register) from the
Modbus RTU Slave modules. And by PMC/PMD IF-THEN-ELSE rule
Figure7-41 :
this nickname will be displayed on the "I/O Information" and
"Rule Setting" pages.
dropdown list.
M-7000 AO Channel Setting Page
105