Figure11-27 : Ao Action Setting Page - ICP DAS USA PMC-523 Series User Manual

ICP DAS PMC-523x/PMC-224x/PMD Series User Manual
Follow the steps below:
i
ii Specify the output value of DO Channel from the dropdown
iii Specify the "Frequency" to be "One-Time" or "Repeat".
iv Specify the value in the "Waiting Time" field, it means after
v Click "OK" button to confirm the settings and return to the
11.2.1.3 AO
You can execute an action in AO channel of XV-Board/M-7000
module in THEN/ELSE Action statement; the editing page for AO
Action is shown as follow:
Follow the steps below:
i
ii Specify the Operator to be "=", "+=", or "-=" from the
Specify the module and channel from the dropdown list of the
"Module & Channel" section.
list of the "Status" field. The output value can be "OFF", "ON"
or "Pulse Output" (Pulse Output applies to XV-Board
For M-7088 belongs to PWM
modules, the DO channel Action will be "Start PWM" or "Stop
PWM".
the action be executed, how long the system will delay to
execute the next Action. The unit will be second(s).
Rule settings page.

Figure11-27 : AO action setting page

From the dropdown list of the "Module & Channel" field,
select the AO channel to execute actions.
dropdown list in the "Operator" field. The 3 operators are as
follow：
 "="：Indicate assign the new AO channel value as the
(Pulse width modulation)
only).
215