ICP DAS PMC-523x/PMC-224x/PMD Series User Manual
Follow the steps below:
i
ii Specify the Operator in the "Operator" field. The 3 operators
iii Set up the value in the "Value" field, PMC/PMD provides 7
iv Specify the "Frequency" to be "One-Time" or "Repeat".
v Specify the value in the "Waiting Time" field, it means after
vi Click "OK" button to confirm the settings and return to the
11.2.3 Power Meter
Click on "Power Meter", 1 option "Power Relay" will appear. You can
execute an action to change the Power Relay status of the Power Meter
in the THEN/ELSE Action statement; the editing page for Power Relay
Action of Power Meter is shown as follow:
Select the module and address of the Holding Register from
the dropdown list of the "Module & Address" section.
are as follow:
"=":Indicate assign the new Holding Register value as the
value in "Value" field.
"+=":Indicate assign the new Holding Register value as
the original Holding Register value plus the value in
"Value" field.
"-=":Indicate assign the new Holding Register value as
the original Holding Register value minus the value in
"Value" field.
value options. Please refer to
detailed information for value settings of these 7 options.
the action be executed, how long the system will delay to
execute the next Action. The unit will be second(s).
Rule settings page.
Figure11-30 : Power Meter Relay Action setting page
"11.2.1.3
AO" section for more
219