Figure11-2 : Rules Setting Page - ICP DAS USA PMC-523 Series User Manual

ICP DAS PMC-523x/PMC-224x/PMD Series User Manual
 Nickname: Input name in the "Nickname" field and you could also input
the description of this Rule in the "Description" field.
 Status: Select "Enable" or "Disable". If you select "Enable", the rule will
be executed after being downloaded. If you select "Disable" the rule will
only be stored temporarily and will not be executed after being downloaded.

IF Condition Setting: More detailed information, please refer to
Condition.

THEN/ELSE Action Setting: More detailed information, please refer to
11.2 THEN/ELSE

Save: After finish all IF Condition and THEN/ELSE Action setting, click on
"Save" to save the settings.
Please note: if you make modification in Power meter setting, IO module
setting or in Advanced Setting after finish defining the rules, it might cause
unexpected error due to the changes, some variables may no longer exist.
Therefore, in case you make any modification, please double check your
settings and Rules definition to make sure no errors are present.
When user finish settings of an IF Condition or THEN/ELSE Action, after going back
to the Rule Information Setting page, a function component will be displayed under
the IF Condition or THEN/ELSE Action section(shown as below), the function
component will display the settings information of the IF-THEN-ELSE logic rule.
The function component (IF Condition, THEN Action or ELSE Action) provides
various functions such as:
Figure11-2 :
Action.
Rules setting page
11.1 IF
194