Removing The I/O Module; Figure 8: Snap The I/O Module Into Place (Example); Figure 9: Removing The I/O Module (Example) - WAGO 750-457/040-000 Manual

4ai +/-10v dc s.e. /xtr, 4-channel analog input module, ±10 v, single-ended /xtr for wago-i/o-system 750 xtr series
Table of Contents

Advertisement

WAGO-I/O-SYSTEM 750 XTR
750-457/040-000 4AI +/-10V DC S.E. /XTR
2.
Press the I/O module into the assembly until the I/O module snaps into the
carrier rail.

Figure 8: Snap the I/O Module into Place (Example)

With the I/O module snapped in place, the electrical connections for the data
contacts and power jumper contacts (if any) to the fieldbus coupler/controller or
to the previous or possibly subsequent I/O module are established.
5.2.2

Removing the I/O Module

1.
Remove the I/O module from the assembly by pulling the release tab.

Figure 9: Removing the I/O Module (Example)

Electrical connections for data or power jumper contacts are disconnected when
removing the I/O module.
Mounting
37
Manual
Version 1.3.0

Advertisement

Table of Contents
loading

Table of Contents