Diagnostic Tool Connection Procedure; Diagnostic Connector Positions - Kubota 07-CR-E5 Manual

07-CR-E5,07-CR-TE5,07-CR-TIE5, DM

2. DIAGNOSTIC TOOL CONNECTION PROCEDURE

[1] DIAGNOSTIC CONNECTOR POSITIONS

[2] DIAGNOSTIC TOOL CONNECTION PROCEDURE
IMPORTANT
• At first time usage, it is necessary to do "Communication Setting" with administrator user account.
• Prepare a PC on which the diagnostic software has already been installed.
• When connecting the diagnosis cable, ensure that the key switch on the machine side is OFF.
1. Refer to the operator's manual for this machine to check the
position for connecting the diagnosis tool.
(1) Terminal IG-SW (V13, V33)
(2) Terminal CAN1-H (V36)
(3) Terminal S-GND (V60)
(4) Terminal CAN1-L (V16)
1. Start up a PC on which the diagnostic software has been
installed with administrator user account.
2. Connect the machine-side CAN1 connector (a) to the interface
connector (To Machine) (2) with the cable (To Machine) (1).
3. Connect the cable (USB) (4) to the USB connector (To PC) (3)
and then connect the USB cable to the USB port on PC.
4. Start the diagnostic software.
5. Select "Communication Setting" from "System Setting" in the
menu and execute. (Only when performing the initial settings.)
NOTE
• The USB port used while the "Communication Setting"
process, should always be used.
(1) Cable (To Machine)
(2) Interface Connector (To Machine)
(3) USB Connector (To PC)*
(4) Cable (USB)
* Rubber cap is attached to USB connector and DC jack each
1-S8
COMMON RAIL SYSTEM
(a) CAN1 Connector
9Y3200007CRS0010US0
9Y3200007CRS0011US0
(5) DC Jack (Reserved)*
(a) CAN1 Connector
9Y3200007CRS0012US0
KiSC issued 03, 2022 A