Excessive Pm5 (Dtc P3008 / 3701-0) - Kubota 07-CR-E5 Manual

07-CR-E5,07-CR-TE5,07-CR-TIE5, DM

(60) Excessive PM5 (DTC P3008 / 3701-0)

Behaviour during malfunction:
• Insufficient output
Detection item:
• PM accumulation level 5
DTC set preconditions:
• Battery voltage is normal
DTC set parameter:
• PM accumulation more than trigger level
Regeneration level = 5
Engine warning light:
• ON
Limp home action by engine ECU (system action):
• Output limitation: Approximately 50 % of normal condition
Recovery from error:
• Key switch turn OFF (Reset by Service tool)
1. Replace the DPF
1. Replace the DPF.
NOTE
• Followings are potential causes.
– A manual regeneration has not been carried out.
(1) DPF Outlet Body
(2) DPF Filter Comp
(3) DOC Catalyst
1-S299
COMMON RAIL SYSTEM
9Y3200007CRS0467US0
(4) DPF Gasket
(5) DPF Gasket
9Y3200007CRS0468US0
KiSC issued 03, 2022 A