Kubota 07-CR-E5 Manual page 236

07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
2. Check the Voltage Between Camshaft Position Sensor
Terminals
1. Place the key switch in the OFF position, and unplug the
camshaft position sensor connector from the socket.
2. Place the key switch in the ON position, and measure the
voltage between G-VCC and G-GND terminals at the wiring
harness side.
Service
Approx. 5 V
specification
OK Go to "3. Check the Connectors".
NG Go to "5. Measure the Engine ECU Terminal Voltage".
(1) Terminal G+
(2) Terminal G-GND
(3) Terminal G-VCC
3. Check the Connectors
1. Check the sensor and wiring harness connectors for incorrect
connection, inappropriate fitting, poor contact or other faulty
areas.
Service Must be free from incorrect connection, inappropriate fitting,
specification poor contact.
OK Go to "4. Check the Wiring Harness".
NG Repair or replace.
(1) Terminal G+
(2) Terminal G-GND
(3) Terminal G-VCC
4. Check the Wiring Harness
1. Check the wiring harness between G+ terminal of sensor and
engine ECU for a short or an open circuit.
Service
Must be free from shorts and open circuit.
specification
OK The sensor has abnormality. → Replace.
NG Replace.
(1) Terminal G+
(2) Terminal G-GND
(3) Terminal G-VCC
1-S198
COMMON RAIL SYSTEM
(a) Pin Assignment
9Y3200007CRS0280US0
(a) Pin Assignment
9Y3200007CRS0281US0
(a) Pin Assignment
9Y3200007CRS0282US0
KiSC issued 03, 2022 A