Kubota 07-CR-E5 Manual page 251

07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
(1) Terminal A-GND3 (2) Terminal IDOC
1. Check the Exhaust Gas Temperature Sensor Signals
1. Place the key switch in the ON position, and check the "Exhaust
gas temperature" and "Exhaust gas temperature sensor output
voltage" on the diagnosis tool data monitor.
Actual exhaust gas
temperature
100 °C (212 °F)
150 °C (302 °F)
200 °C (392 °F)
250 °C (482 °F)
OK
NG
(a) CAN1 Connector
1-S213
(a) Pin Assignment
(b) Exhaust Gas Temperature
Sensor (T )
0
Service specification
Exhaust gas
temperature
100 °C (212 °F)
150 °C (302 °F)
200 °C (392 °F)
250 °C (482 °F)
Clear the DTC and check whether it is output again or not.
OK Normal.
NG Replace the engine ECU.
Go to "2. Measure the Resistance Between Terminals".
COMMON RAIL SYSTEM
(c) Engine ECU Connector 1
(Engine Side)
(d) Engine ECU
9Y3200007CRS0314US0
Output voltage
Approx. 4.4 V
Approx. 3.7 V
Approx. 3.0 V
Approx. 2.3 V
9Y3200007CRS0315US0
KiSC issued 03, 2022 A