Kubota 07-CR-E5 Manual page 328

07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
2. Check the DTC
1. Place the key switch in the OFF position, and attach the
diagnosis tool to the CAN1 connector.
2. Turn the key switch to the ON position and select the "Exhaust
Gas Temperature sensor 0", "Exhaust gas temperature sensor
1" and "Exhaust gas temperature sensor 2" on the data
monitor.function.
3. Check whether the DTC is output or not after starting up the
engine by monitoring the data signals.
Service
No DTC is output.
specification
OK Normal.
NG Go to "3. Check the Exhaust Gas Temperature Sensor".
(a) CAN1 Connector
3. Check the Exhaust Gas Temperature Sensors
1. Check the exhaust gas temperature sensors (T
OK Normal.
NG Replace the exhaust gas temperature sensor or engine combustion main
parts. (Follow the diagnostic procedure of items P0543, P0546 and
P242C)
(1) Terminal A-GND3
(2) Terminal IDOC, ODOC or ODPF
1-S290
COMMON RAIL SYSTEM
9Y3200007CRS0447US0
, T and T
0 1
(a) Exhaust Gas Temperature
Sesnsor (T , T and T )
0 1 2
9Y3200007CRS0448US0
KiSC issued 03, 2022 A
).
2