Kubota 07-CR-E5 Manual page 330

07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
2. Check the Exhaust Gas Temperature
1. Place the key switch in the OFF position, and attach the
diagnosis tool to the CAN1 connector.
2. Turn the key switch to the ON position and select the "Exhaust
gas temperature Sensor 0", "Exhaust gas temperature Sensor
1" and "Exhaust gas temperature Sensor 2" on the data
monitor.function.
3. If the exhaust gas temperature is above 300 °C (572 °F), wait till
the temperature decreases below 300 °C (572 °F).
Service The actual exhaust gas temperature and monitoring exhaust
specification gas temperature should be approximately the same.
OK Go to "4. Check the DTC".
NG Go to "3. Check the Exhaust Gas Temperature Sensors (Refer to items
P0543, P0546 and P242C)".
(a) CAN1 Connector
3. Check the Exhaust Gas Temperature Sensors (Refer to items
P0543, P0546 and P242C)
1. Check the exhaust gas temperature sensors (T
OK Go to "4. Check the DTC".
NG Replace the exhaust gas temperature sensor or engine combustion main
parts. (Follow the diagnostic procedure of items P0543, P0546 and
P242C)
(1) Terminal A-GND3
(2) Terminal IDOC, ODOC or ODPF
4. Check the DTC
1. Check the engine noise and vibration after starting up the
engine.
Check whether turbocharger has abnormality. (sound and
externals)
2. Check whether the other DTC is output or not by operating the
engine in the normal condition.
3. If it is OK, restart and operate the engine for 10 minutes with the
engine in the no-load maximum speed status.
Check whether the DTC is output or not.
Service
No DTC is output.
specification
OK Normal.
NG Replace the exhaust gas temperature sensor or engine combustion main
parts. (Follow the diagnostic procedure of items P0543, P0546 and
P242C)
(a) CAN1 Connector
1-S292
COMMON RAIL SYSTEM
9Y3200007CRS0451US0
, T and T
0 1
(a) Exhaust Gas Temperature
Sesnsor (T , T and T )
0 1 2
9Y3200007CRS0452US0
9Y3200007CRS0453US0
KiSC issued 03, 2022 A
).
2