Kubota 07-CR-E5 Manual page 97

07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
3. Check the Starting Assist Device
1. Refer to the workshop manual for the machine and check the
glow plug, relay and related wiring harness.
2. Perform an active test for models that have relay control in the
engine ECU on the engine side.
Service Operates repeatedly between ON and OFF in accordance
specification with the specified cycle.
OK Go to "4. Check the Idle Condition".
NG Checking and replace starting assist device (glow plug).
(a) CAN1 Connector
4. Check the Idle Condition
1. Check if idling is normal.
Service
Stable at specified speed.
specification
OK Go to "5. Check the Intake System".
NG Refer to "(4) Idle Failure", and implement checking and repair.(Refer to
page 1-S39)
5. Check the Intake System
1. Check in accordance with "6.[1] AIR INTAKE SYSTEM
INSPECTION PROCEDURE". (Refer to page 1-S320)
OK Go to "6. Check the Fuel System".
NG Repair in accordance with "6.[1] AIR INTAKE SYSTEM INSPECTION
PROCEDURE". (Refer to page 1-S320)
6. Check the Fuel System
1. Check in accordance with "6.[2] FUEL SYSTEM INSPECTION
PROCEDURE". (Refer to page 1-S321)
OK Go to "7. Check the Crankshaft Position Sensor".
NG Repair in accordance with "6.[2] FUEL SYSTEM INSPECTION
PROCEDURE". (Refer to page 1-S321)
(1) Rail
7. Check the Crankshaft Position Sensor
1. Refer to DTC P0335 and P0336, and implement checking of the
crankshaft position sensor.
OK Go to "8. Check the Camshaft Position Sensor".
NG Replace the crankshaft position sensor-related parts.
(1) Crankshaft Position Sensor
(NE Sensor)
1-S59
COMMON RAIL SYSTEM
9Y3200007CRS0094US0
9Y3200007CRS0095US0
9Y3200007CRS0096US0
(2) Supply Pump
9Y3200007CRS0097US0
9Y3200007CRS0049US0
KiSC issued 03, 2022 A