07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
5. Measure the Voltage Between Sensor Terminals
1. Keep the accelerator position sensor connector plugged into
socket.
2. Measure the voltage between terminals (2) and (3) of
accelerator position sensor connector (at the machine wiring
harness side).
Accelerator pedal fully closed: 1.35 V or lower
Service
Accelerator pedal full throttle: 4.0 V or higher
specification
Follow the OEM adjusted value : 1.1 to 1.35 V, 4.0 to 4.2 V
OK
Wiring harness open circuit, short → Check and replace.
NG
Faulty accelerator sensor → Replace.
(1) Terminal A-VCC11
(2) Terminal APS1
(3) Terminal APS1 GND
(4) Terminal A-VCC10
(5) Terminal APS2
(6) Terminal APS2 GND
1-S251
COMMON RAIL SYSTEM
(a) Pin Assignment
9Y3200007CRS0384US0
KiSC issued 03, 2022 A