Engine Stalls On Deceleration - Kubota 07-CR-E5 Manual

07-CR-E5,07-CR-TE5,07-CR-TIE5, DM

(10) Engine Stalls On Deceleration

Possible causes:
1. Fuel feed pump operation fault.
*Refer to the previous "List of malfunction causes by symptom" for the subsequent details.
2. Engine fault
• Low compression pressure.
• Engine internal fault
• Valve timing fault
3. Control system
• Damage to the pulsar gear of the crankshaft position sensor
• Air gap of the crankshaft position sensor is large
• SCV operation fault
4. Intake system
• Air cleaner clogging
5. Fuel system
• Fuel quality
• Fuel filter clogging
• Fuel line clogging, leak
6. CRS (including the wiring harness)
• Output system (supply pump, injector and common rail)
• Input system (sensors and switches)
• Engine ECU
1. Check the Fuel Feed Pump Operation
1. Turn the key switch ON and check that the fuel feed pump is
operating.
Service
Operates when the key switch is turned ON.
specification
OK Go to "2. Check the DTC".
NG Check in accordance with "6.[2] FUEL SYSTEM INSPECTION
PROCEDURE - 5. Check the Fuel Feed Pump". (Refer to page 1-S324)
(1) Fuel Feed Pump
2. Check the DTC
1. Turn the key switch ON and check the DTC.
Service
No DTC is output.
specification
DTC presently existing
OK Go to "3. Check the idle condition".
NG Check in accordance with the troubleshooting procedures for each DTC.
Past DTC only
OK Go to "3. Check the idle condition".
NG Reproduce defect by referring to the freeze frame data, etc.
(a) CAN1 Connector
1-S63
COMMON RAIL SYSTEM
9Y3200007CRS0101US0
9Y3200007CRS0027US0
9Y3200007CRS0102US0
KiSC issued 03, 2022 A