Kubota 07-CR-E5 Manual page 88

07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
2. Check the DTC
1. Turn the key switch ON and check the DTC.
Service
No DTC is output.
specification
DTC presently existing
OK Go to "3. Check the Accelerator Position Sensor.
NG Check in accordance with the troubleshooting procedures for each DTC.
Past DTC only
OK Go to "3. Check the Accelerator Position Sensor.
NG Reproduce defect by referring to the freeze frame data, etc.
(a) CAN1 Connector
3. Check the Accelerator Position Sensor
CAUTION
• When checking, pay attention to the angle of mounting
instead of the output signal quality.
1. Inspect in accordance with the operator's manual.
OK Go to "4. Check the Idle Condition".
NG Replacement of accelerator position sensor.
4. Check the Idle Condition
1. Check if idling is normal.
Service
Stable at specified speed.
specification
OK Go to "5. Malfunction Verification - 1".
NG Refer to "(4) Idle Failure", and implement checking and repair.(Refer to
page 1-S39)
5. Malfunction Verification - 1
1. Reproduce running conditions (engine speed, machine speed,
gear shift, etc.) as pointed out by the driver. Compare with
another machine of the same model and check whether poor
acceleration and power shortage can be sensed.
Service
No malfunction should be detected.
specification
OK Explain to the driver that the machine is in a normal condition.
(Reference)
• Give appropriate advice to the driver about matters concerning
anything noticed that is related to his driving manner (such as
selection of shift, etc.).
NG Go to "6. Malfunction Verification - 2".
1-S50
COMMON RAIL SYSTEM
9Y3200007CRS0071US0
9Y3200007CRS0072US0
9Y3200007CRS0073US0
9Y3200007CRS0074US0
KiSC issued 03, 2022 A