Kubota 07-CR-E5 Manual page 158

07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
Name
ISO 14229
P-Code
SPN
J1939-73
FMI
SPN Name Aftertreatment 1 Exhaust Gas
SAE J1939 Table C1 Temperature 3 Preliminary FMI
Emergency
DTC Name
Exhaust gas temperature sensor 2: High
Detection item
DTC Set
Preconditions
DTC set parameter
Time to action or
number of error
detection
Limp Home Action
by engine ECU
(system action)
Behaviour During
Malfunction
Engine Warning
Light
Recovery from
error
Delay time for
recovery
Remark
Exhaust gas temperature sensor (T
• Exhaust gas temperature (T
• Exhaust gas temperature sensor T
• Battery voltage is normal
• DPF outlet temperature (T
• 2.0 sec. or more
• Stop injection (Q = 0 mm
• Engine stop
• EGR stop
• Intake throttle 0 % open (Close)
• Inhibit starter relay activation until exhaust gas temperature reduces down to 300 °C
(572 °F)
• Engine stops
• Inhibitef cranking until down to 300 °C (572 °F)
• ON
• Under 300 °C (572 °F) & key switch turn OFF
• In case engine ECU is not involved to drive starter, starter activation should be inhibited
by other way until exhaust gas temperature reduces down to 300 °C (572 °F)
2
P3004
3246
0
) high
2
,T and T are normal
0 1 2
): 820 °C (1508 °F) or more
2
3
/st)
–
1-S120
COMMON RAIL SYSTEM
) Emergency high
9Y3200007CRS0156US0
KiSC issued 03, 2022 A