Engine Disassembly And Reassembly Procedure; Removing Cylinder Head Cover; Removing Alternator And Fan Belt; Removing Rocker Arm And Push Rod - Kubota D1102-B Workshop Manual

2.DISASSEMBLY AND REASSEMBLY
• ATTENTION: When reassembling, replace all the 0-ring and gaskets by new ones.
0

Removing Cylinder Head Cover

1) Remove cap nuts from the cylinder head cover.
2) Remove the cyl inder head cover and the gasket from the
cyl inder head.
( Note for reassembl ing)
• Tighten the cap nu ts to 6.9 to 8.8 N•m. (0.7 to 0.9
kgf·m, 5.1 to 6.5 lb.ft.)
• Be caref ul to ref it the breather oil shield in the right
direction.
8

Removing Alternator and Fan Belt

1) Remove the alternator.
2) Detach the fan bel t.
( Note for reassembling)
• Fan belt tension
The belt should def lect approx. 7 to
0.3543
in.) when the center of belt is depressed with a
finger pressu re of 58.8
15.4 l b.)
C,

Removing Rocker Arm and Push Rod

1) Detach the rocker arm.
2) Remove the push-rods.
( Note for reassembl ing)
• I nsert the push-rods into the tappets secu rely.
• Tigh ten the rocker arm bracket mou nting nuts to 23.5 to
27.5 N-m. (2.4 to 2.8 kgf ,m, 17.4 to 20.3 l b.f t.)
35
9
mm (0.2756 to
to 68.6 N. (6 to 7 kgf ., 13.2
KiSC issued 09, 2007 A
to