Kubota 07-CR-E5 Manual page 230

07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
(1) Terminal A-VCC1
(2) Terminal NE−
(3) Terminal NE+
(a) Pin Assignment
(b) Crankshaft Position Sensor
(NE Sensor)
1. Check the Crankshaft Position Sensor Signals
1. Rotate the engine, and check the "Engine speed active flag"
value on the diagnosis tool data monitor.
Service
specification
OK
NG
(a) CAN1 Connector
1-S192
(c) NE Sensor Input Circuit
(d) Engine ECU Connector 1
(Engine Side)
Always ON
It should be confirmed two or more times while changing the accelerator.
OK Normal.
NG Go to "2. Check the Voltage Between Crankshaft Position
Sensor Terminals".
Go to "2. Check the Voltage Between Crankshaft Position Sensor
Terminals".
COMMON RAIL SYSTEM
(e) Engine ECU
9Y3200007CRS0266US0
9Y3200007CRS0267US0
KiSC issued 03, 2022 A