07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
(1) Terminal G+
(2) Terminal G-GND
(3) Terminal G-VCC
(a) Pin Assignment
(b) Camshaft Position Sensor
(G Sensor)
1. Check the Camshaft Position Sensor Signals
1. Rotate the engine, and check the "Cam speed active flag" value
on the diagnosis tool data monitor.
Service
specification
OK
NG
(a) CAN1 Connector
1-S197
(c) G Sensor Input Circuit
(d) Engine ECU Connector 1
(Engine Side)
Always ON
It should be confirmed two or more times while changing the accelerator.
OK
Normal.
NG
Go to "2. Check the Voltage Between Camshaft Position Sensor
Terminals".
Go to "2. Check the Voltage Between Camshaft Position Sensor
Terminals".
COMMON RAIL SYSTEM
(e) Engine ECU
9Y3200007CRS0278US0
9Y3200007CRS0279US0
KiSC issued 03, 2022 A