Kubota 07-CR-E5 Manual page 325

07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
(1) No Connection
(2) Terminal A-VCC10 (+5 V)
(3) Terminal ITS (Output)
(4) Terminal A-GND11 (Ground)
(5) Terminal ITV+
(6) Terminal ITV–
1. check the intake throttle signal
1. after operating the engine, perform an active test.
monitor the "actual intake throttle valve opening" and "intake
throttle opening output voltage", and check the values.
* for details, refer to the active test section.
2. clear the dtc and check whether it is output again or not.
Service
specification
OK
NG
(a) CAN1 Connector
1-S287
(a) Pin Assignment
(b) Intake Throttle Valve
(c) Engine ECU Connector 1
(Engine Side)
No DTC is output.
Normal.
Go to "2. Checking Wiring Harness".
COMMON RAIL SYSTEM
(d) Engine ECU Connector 2
(Machine Side)
(e) Engine ECU
9Y3200007CRS0375US0
9Y3200007CRS0376US0
KiSC issued 03, 2022 A