AutomationDirect C0-USER-M Manual page 36

Table of Contents

Advertisement

Chapter 1: Getting Started
Step 6: Establish PC to PLC Communications, (cont'd)
Next, the new IP Address needs to start with '10.11' to match the subnet of the PC. The
following 2 numbers however, can be any number as long as the new IP Address is unique in
the LAN. In the window here, the IP Address was changed to '10.11.0.24'.
Click the OK button to continue. The new IP Address setup is sent to the CLICK PLC.
Your PC and the CLICK PLC locate in the same subnet now. Click the Connect button on
the bottom to connect the CLICK programming software to the CLICK PLC.
1–22
CLICK PLC Hardware User Manual, 6th Edition, Rev. F – C0-USER-M
To match the subnet setup of the CLICK PLC to the
subnet that the your PC locates in, select the CLICK
PLC unit in the list and click the Edit button under the
list. The Edit window opens.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the C0-USER-M and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

C0-01ac

Table of Contents