Table of Contents
Advertisement
Terminals of controller
CAN GND
CAN(H)
CAN(L)
Engine type: Common J1939.
16.14 PERKINS
It is suitable for ADEM3/ADEM4 engine control module. Engine type is 2306, 2506, 1106, and 2806.
Terminals of controller
Fuel relay output
Starting relay output
CAN GND
CAN(H)
CAN(L)
Engine type: Perkins.
16.15 SCANIA
It is suitable for S6 engine control module. Engine type is DC9, DC12, and DC16.
Terminals of controller
Fuel relay output
Starting relay output
CAN GND
CAN(H)
CAN(L)
Engine type: Scania.
16.16 VOLVO EDC3
Suitable engine control mode is TAD1240, TAD1241, and TAD1242.
Terminals of controller
Fuel relay output
Starting relay output
Programmable output 1
HGM9510 Genset Parallel Controller User Manual
Table 38 SAM (X23 port)
SAM (X23 port)
X23 3
X23 2
X23 1
Table 39 Connector
Connector
1, 10, 15, 33, 34
-
-
31
32
Table 40 B1 Connector
B1 connector
3
-
-
9
10
Table 41 "Stand alone" Connector
"Stand alone" connector
H
E
P
Remark
CAN communication shielding line (connect
with controller's this terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Remark
Connect to starter coil directly.
CAN communication shielding line (connect
with controller's terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Remark
Connect to starter coil directly.
CAN communication shielding line (connect
with controller's terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Remark
ECU power;
Set programmable output 1 as "ECU power".
Page 64 of 68
Advertisement
Table of Contents
