Scania; Volvo Edc3 - Smartgen HGM8140D User Manual

13.15 SCANIA

It is suitable for S6 engine control module. Engine type is DC9, DC12, and DC16.
Terminals of controller
Relay Output 1
Start relay output
CAN_SCR
CAN(H)
CAN(L)
Engine type: Scania

13.16 VOLVO EDC3

Suitable engine control mode is TAD1240, TAD1241, and TAD1242.
Terminals of controller "Stand alone" connector
Relay Output 1
Start relay output
Auxiliary output 1
Terminals of controller
CAN_SCR
CAN(H)
CAN(L)
Engine type: Volvo
NOTE: When this engine type is selected, preheating time should be set to at least 3 seconds.
HGM8140 Military Genset Controller
HGM8140 MILITARY GENSET CONTROLLER USER MANUAL
Table 37 B1 Connector
B1 connector
3
-
-
9
10
Table 38 "Stand alone" Connector
H
E
P
Table 39 "Data bus" Connector
"Data bus" connector
-
1
2
Configure relay output 1 as "Fuel Output".
Connect to starter coil directly.
CAN communication shielding line.
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Configure relay output 1 as "Fuel Output".
ECU power
Configurable output 1,"ECU power".
CAN communication shielding line.
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Version 1.2 2019-09-12
Remark
Remark
Remark
Page 52 of 56