Scania; Volvo Edc3; Volvo-Ems2 - Smartgen HEM4300 User Manual

13.7 SCANIA

Suitable for S6 engine control module.
Terminals of controller
Aux. output 1
Aux. output 2
CAN(H)
CAN(L)
Engine type: SCANIA-S8.

13.8 VOLVO EDC3

Suitable engine control mode is TAD1240, TAD1241, and TAD1242.
Terminals of controller
Aux. output 1
Aux. output 2
Aux. output 3
Terminals of controller
CAN(H)
CAN(L)
Engine type: VOLVO-EMS2.
NOTE: When this engine type is selected, preheating time should be set to at least 3 seconds.

13.9 VOLVO-EMS2

Volvo Engine models are TAD734, TAD940, TAD941, TAD1640, TAD1641, and TAD1642.
Terminals of controller
Aux. output 1
Aux. output 2
-
-
CAN(H)
CAN(L)
Engine type: VOLVO-EMS2.
NOTE: When this engine type is selected, preheating time should be set to at least 3 seconds.
HEM4300 Engine Controller User Manual
Table 26 B1 Connector
B1 connector
3
-
9
10
Table 27 "Stand alone" Connector
"Stand alone" connector
H
E
P
Table 28 "Data Bus" Connector
"Data bus" connector
1
2
Table 29 Engine CAN Port
Engine's CAN port
6
5
3
4
1(Hi)
2(Lo)
Remark
Configure it as "Fuel Output".
Configure it as "Crank Output". Connect to
starter coil directly via expand relay.
Using twisted-pair shielded line with single
end grounded.
Remark
Configure it as "Fuel Output".
Configure it as "Crank Output". Connect to
starter coil directly via expand relay.
Configure it as "ECU power".
Remark
Using twisted-pair shielded line with single
end grounded.
Remark
Configure it as "ECU stop".
Configure it as "ECU power".
Negative power.
Positive power.
Using twisted-pair shielded line with single
end grounded.
Page 53 of 55