Omron OMNUC G Series User Manual page 209

Ac servomotors/servo drives with built-in mechatrolink-ii communications

Hide thumbs Also See for OMNUC G Series:

Installing Decelerator into the Machine

When you install the R88G-VRXF into the machine, confirm that the mounting surface is flat

and there are no burrs on the tap sections, and fix the mounting flange with bolts.

Bolt tightening torque on the mounting flange (for aluminum)

Number of bolts

Size of bolts

Mounting PCD (mm)

Tightening torque (N·m)

Note If the key on a Servomotor with key is uninstalled, it is possible to use the Decelerator by

installing the Servomotor without above mentioned key.

Slipping does not occur.

4-1 Installation Conditions

Chapters