Table of Contents
Advertisement
ICP DAS PMC-523x/PMC-224x/PMD Series User Manual
1. Do not modify the channel value encoded string when you are
editing the formula. It may cause failures when PMC/PMD reads
the power data or I/O channel value.
2. Before you click the "Test" button, please confirm that the power
meter and I/O module setting is saved to PMC/PMD if you use the
power data or I/O channels in the formula. Otherwise, the test
result would be error because the power meter or I/O module is not
found.
iv Click on "OK" to confirm the setting and leave the setting page.
v
Repeat steps i~iv to complete settings of all Internal Register setting.
vi To modify the settings of a pre-set Internal Register, please click on the
radio button in front of the Internal Register, and then click on
"Setting" to modify the settings.
vii To copy the settings of a pre-set internal register to the new internal
register, please click the radio button in front of the pre-set internal
register and then click "Copy", a new internal register(in sequence)
will be added to the list and the settings of the old internal register will
be copied to this newly added internal register.
viii To remove a pre-set internal register, please click the radio button in
front of the pre-set internal register and then click "Remove".
ix After you finish all the Internal Registers selections and settings, click
"Save" button to save the settings.
10.9 Ping Setting
PMC/PMD provides the Ping function to detect the connection status
between the PMC/PMD controller and specified Ethernet devices. The
results of Ping function can be used as IF conditions. The settings steps are
as below:
Click on "Add new Ping" to add a new Ping target.
i
After clicking the "Add new Ping", a setting page will appear, input a
ii
Figure10-39 : Ping List Page
193
Advertisement
Table of Contents
