Table of Contents
Advertisement
ICP DAS PMC-523x/PMC-224x/PMD Series User Manual
Follow the steps below:
i. In the "Function Status" field, check "Enable" to enable the Real-Time
data upload operation.
ii. In the "Add Channel" section, select the "Interface", "Module" and
"Channel" from the dropdown list and click "Insert" to add the power
meter loop or I/O channel into the "Channel List" section. User can
select "All" in "Channel" field to insert all power meter loops and I/O
channels of the power meter or I/O module at once.
iii. PMC/PMD will actively send the Real-Time power data and I/O data
which is located in the "Channel List" section to IoTstar. User can
modify the database field name of the power data (or I/O channel data)
in the "*Name" field. To remove a pre-set power meter loop or I/O
channel, please click the radio button in front of the pre-set power
meter loop or I/O channel and then click "Remove" button.
Please Note:
1. The name inputted in the "*Name" field must be a unique name.
2. The name set in the "*Name" field will be saved in the "Name" field
of the Real-Time Data Table that IoTstar creates for the PMC/PMD
(Please refer to Appendix VI of IoTstar User Manual). These names
can be used later for further query operations of the Database.
iv. After all settings are completed, click "Save" button to save the setting.
9.5
IoTstar Historical Data Sending Setting
IoTstar can receive the historical power data (and I/O data) uploaded by
PMC/PMD, and import these data into the database it created. The setting
page is shown as below:
160
Advertisement
Table of Contents
