ICP DAS USA PMD Series User Manual page 107

ICP DAS PMC-523x/PMC-224x/PMD Series User Manual
The settings are as follow:
 Nickname：For user to define nicknames for each power meter,
 Description: The Description field provides a space for the user
 IP: The address will be the IP address of this power meter,
 Port: The setting will be the Port number of this power meter,
 NetID: The setting will be the NetID of this power meter, please
 Scan Rate: Input the time interval for PMC/PMD to periodically
 Polling Timeout: The time interval for PMC/PMD to send
 Retry Interval: The time interval to wait for PMC/PMD to
 Main Power Meter: When the "Set as main power meter" is
 CT/Phase Nickname: For user to define nicknames for each CT
this nickname will be displayed on the "Power Meter
Information" and "Rule Setting" pages.
to make a brief description of this power meter.
please make sure the IP address setting is the same as the
settings of the module, if the setting is not accurate, the
connection for PMC/PMD to the power meter will be failed.
please make sure the Port number is the same as the settings of
the module, if the setting is not accurate, the connection for
PMC/PMD to the power meter will be failed.
make sure the NetID is the same as the settings of the module,
if the setting is not accurate, the connection for PMC/PMD to
the power meter will be failed.
retrieve the power data of this Modbus TCP Power Meter, the
setting range will be 0 ~ 65535 seconds.
command to the Modbus TCP Power Meter and wait for the
response, the unit will be ms. The setting range will be 1-10000
ms.
repeatedly send command again when PMC/PMD sends
command to the Modbus TCP Power Meter and get no response.
The unit will be second. the setting range will be 3 ~ 65535
seconds.
selected, this power meter will be set as main power meter and
the power data of this meter will be displayed on the Main
Power Meter area on the "Power Data Overview" page.
(or phase), this nickname will be displayed on the "Power
Meter Information" and "Rule Setting" pages. For single-phase
power meter, the user could give nicknames to the CT1/ CT2/
92