M-7000/Dl/Ir Module Setting - ICP DAS USA PMD Series User Manual

ICP DAS PMC-523x/PMC-224x/PMD Series User Manual
 Remove: Click the radio button in front of the Modbus I/O
After all settings are completed, click "Save" button to save the
changes.
7.3.5

M-7000/DL/IR Module Setting

PMC/PMD support ICP DAS M-7000/DL/IR module, the following
section will give more detailed settings of ICP DAS M-7000/DL/IR
module setting page. (Figure 7-38)
 Nickname：For user to define nicknames for each M-7000/DL
 Description: The Description field provides a space for the user
 Address: The address will be the Modbus address of this
 Scan Rate: Input the time interval for PMC/PMD to periodically
 Polling Timeout: The time interval for PMC/PMD to send
 Retry Interval: The time interval to wait for PMC/PMD to
front of the pre-set Modbus I/O module and then click on
"Copy", a new Modbus I/O module (in sequence) will be added
to the list and the settings of the old Modbus I/O module will be
copied to this newly added Modbus I/O module.
module and click on "Remove" to remove the selected Modbus
I/O module.
module, this nickname will be displayed on the "I/O
Information " and "Rule Setting" pages.
to make a brief description of this M-7000/DL module.
M-7000/DL/IR module, please make sure the address is the
same as the settings of the module, if the setting is not accurate,
the connection for PMC/PMD to the M-7000/DL/IR module
will be failed.
retrieve the I/O channel data of this M-7000/DL/IR module, the
setting range will be 0 ~ 65535 seconds.
command to the M-7000/DL/IR module and wait for the
response, the unit will be ms. The setting range will be 1-10000
ms.
repeatedly send command again when PMC/PMD sends
command to the M-7000/DL/IR module and get no response.
The unit will be second. the setting range will be 3 ~ 65535
seconds.
107