Auto Z Stage Zero Calibration - Manual Start - Stratasys Fortus 360mc User Manual

AUTO Z STAGE ZERO CALIBRATION - MANUAL START

Note: An Auto Z Stage Zero Calibration must be performed after running
"Manual Z Stage Zero" on page
calibration.
Note: Perform an Autohome XYZ before Z Stage Zero Calibration (Operator
Control > Calibrate > AutoHome XYZ).
1. Make sure a build sheet is installed and verify that vacuum is present.
2. Run the Auto Z Stage Zero Calibration.
A. From the Main Menu select Operator Control and press Enter.
B. Select Calibrate and press Enter.
C. Select Set Z Stage Zero and press Enter.
D. Select Auto Z Zero Calibrate and press Enter.
E. The system performs an Auto Z Stage Zero Calibration. If Auto Z Stage Zero Calibration
fails, perform
Build Job..
>Operator Control..
Modeler Status..
Maintenance..
Unlock Door <E>
Load/Unload Mtl..
Change Tips/Mtl..
>Calibrate..
>Set Z Stage Zero..
AutoCal Tips <E>
Tip Offset Value..
AutoHome XYZ <E>
Set Manual Z Stage Zero <E>
Modify Current Z Zero..
>Auto Z Zero Calibrate <E>
"Manual Z Stage Zero" on page
72. Use this procedure to manually initiate the
|*Tips: Model T16
|* Support T16
| Temp Control..
| Move Head/Stage..
| Calibration Job <E>
72.
74