Stratasys Fortus 360mc User Manual page 60

•
<E> (Ready)
liquefier tip.
•
(*Ready)- indicates that the material is the current selection for loading to the liquefier tip.
•
(None.)- indicates that a canister is installed, but has not been pre-loaded to the canister bay
drive wheels.
ii.
Press MENU to return to the previous screen. Go to the Select Tips menu.
Note: Selected materials will be loaded as a part of the last item in this
sequential menu - the Reset Tip Odometers.. item.
ii.
Select Tips
iii.
Move the cursor to the Select Tips line.
Caution: The modeler cannot detect the type or size of installed tips. The
operator must correctly select the installed tips from the 'Select Tips' menu. If the
tips selected on the menu do not match the installed tips, part quality will be
affected and liquefier clogs will likely occur.
iv.
Press ENTER to toggle through the available tips until the display matches the tips installed in the
system.
v.
Only tips that are compatible with the loaded material will be displayed.
vi.
Go to the Reset Tip Odometers.. menu.
*M
Review Materials to Load..
Select Tips <E> T12 T12
>Reset Tip Odometers..
iii.
Reset Tip Odometers..
>Reset Model in3
Reset Supp. in3
----------
Unlock Door
vii.
Move the cursor to the line of the tip that was replaced.
viii.
Press Enter to reset the odometer to zero (0.0)
•
If a tip is removed that may be re-installed at a later time, before resetting the tip odometer, record
the displayed odometer reading. Store the reading with the tip that was removed.
•
If a used tip is installed for which previous odometer information is available, enter the stored
reading of the used tip (use the number keys and decimal (.) key), then press ENTER.
ix.
If the build sheet needs to be installed, select Unlock Door, press Enter, and install a new build
sheet.
x.
Move the cursor to the third line of the Reset Tip Odometers.. menu.
Note: The menu choice displayed on the third line is dependent upon the part
build location chosen for the system. For more information, see
Location" on page
- indicates that the material is pre-loaded and can be selected for loading to the
PC [R | * | * | R ]
<E>
<E>
<E>
54.
50
PC_S S*
633.5 ()
182.7 ()
"Part Build