OVEN BAY
OVEN DOOR
The Oven Assembly (also called the Oven Bay) includes the oven door and everything that you see through the
front door glass. The bay is where parts are built. The oven door uses a continuous solenoid. The Unlock Hood/
Door command will release the solenoid allowing you to open the door.
1.
From the Main Menu select
2.
Select
Unlock Door
Note: This command is only available while the system is paused or in an idle
state. You do not have access to this command while the gantry is moving.
3.
If the temperature is high, a warning screen may appear. Press ENTER again to unlock the door.
Note: Once any door is unlocked and/or opened, system operation cannot be
resumed. Additionally, a manual move command cannot be sent until all doors
are closed. When all doors are closed, the solenoids reactivate and you can
resume operation.
OVEN COMPONENTS
Gloves: Oven lights are hot! Do not touch without wearing approved safety
gloves.
OVEN LAMPS
There are two incandescent oven lamps mounted in the two front upper corners of the oven. The lamps are
rated at 240 volts and 40 watts. There is a lamp (light) switch on the keypad, which you can use to manually turn
the light ON or OFF.
(Figure
Figure 3-9:
Oven Lamp
Operator Control
Build Job..
>Operator Control..
Modeler Status..
Maintenance..
and press ENTER.
>Unlock Door <E>
Load/Unload Matl..
Change Tips/Matl..
3-9)
and press ENTER.
| *Tips: Model T16
| *
Support T16
| Calibrate..
| Temp Control..
| Move Head/Stage..
22