Daily Maintenance; Clean The Platen; Empty The Purge Waste Bucket - Stratasys Fortus 360mc User Manual

DAILY MAINTENANCE

CLEAN THE PLATEN

The platen is the surface on which the build sheet is placed for modeling. If debris collects on the platen, it can
adversely affect the vacuum which secures the build sheet to the platen.
1. Remove the build sheet from the platen.
• Lift a corner of the build sheet to break the vacuum holding it to the platen.
• Slide the build sheet from the platen.
2. Carefully remove debris that has fallen into the channels of the platen.
Vacuum or use a soft brush.
•
If a brush is used, brush away from the vacuum port in the center of the platen.
•
• If debris falls into the vacuum port, it can cause a loss of vacuum, resulting in poor adhesion of
the build sheet to the platen during part build.
Note: Do not attempt to remove the vacuum port screen. It is not a customer
replaceable item.
3. Inspect the rubber o-ring and replace if cracks are found.

EMPTY THE PURGE WASTE BUCKET

The purge bucket is located inside the canister bay. It catches the material that has been purged or wiped from
the liquefiers and liquefier tips. The purge bucket should be emptied daily.
1. Open the canister bay door.
2. Rotate the basket counter-clockwise while pulling the basket from the system.
3. Empty the waste material from the purge waste bucket.
4. Reinstall the basket by inserting it into the opening while rotating the basket clockwise.
Figure 7-2: Purge Waste Bucket
(Figure
80
7-2)