Table of Contents
Advertisement
Chapter 3 Basic Operations
Performing Manual Operations
Placing the Library
Off-line
Turning Off the Library
Inserting Tape
Cartridges
52
To place the library off-line:
3
Note: You must have Operator level access privileges or higher to perform
this procedure (see "Changing the GUI Security Level" on page 49).
Procedure
With the library turned on and the GUI indicating "System
1
On-line," press the Standby button on the GUI.
Verify that the GUI displays "System Off-line."
2
To turn off the library:
3
Procedure
Place the library off-line (see the previous section, "Placing the
1
Library Off-line").
The library completes the current command and then stops.
Verify that the GUI displays "System Off-line."
2
Verify that the gripper is empty by checking the Overview screen.
3
If there is a tape cartridge in the gripper, execute a Move command
4
to place the cartridge in an empty bin or drive (see "Moving a
Cartridge" on page 64).
At the front panel, set the power switch off.
5
Caution: Always leave the library power off for at least 15 seconds
before turning it on again.
This section explains how to insert tape cartridges.
3
Note: You must have Import Only level access privileges or higher to
perform this procedure (see "Changing the GUI Security Level" on
page 49).
Caution: Do not use CompacTape I™, CompacTape II™, or
CompacTape IIIXT™ tape cartridges in this library.
ATL P1000 Series User's Guide
Advertisement
Table of Contents
