Turning The Library On And Off; Turning On The Library; Placing The Library On-Line Or Off-Line; Turning Off The Library - Quantum P2000 Series User Manual

Turning the Library On and Off

Turning On the
2
Library
Placing the Library
2
On-line or Off-line
Turning Off the
2
Library
This section explains how to:
Turn the library on
•
Place the library on-line or off-line
•
Turn the library off
•
Test the installation
•
To turn on the library:
Verify that:
1
Power cables are firmly in place
•
All doors are closed
•
Turn on the power switch located behind the small sliding door
2
below the touch screen GUI.
After several seconds, verify that the current state of the library
3
("System On-line" or "System Off-line") appears in the System
State display on the touch screen GUI.
With the library turned on, press the Standby button on the touch
screen GUI.
Pressing the Standby button toggles the library between on-line
and off-line states.
To turn off the library:
Place the library off-line by pressing the Standby button.
1
The library robotics completes any current commands and then
stops.
ATL P2000 Series Automated Tape Library User's Guide
Chapter 2 Basic Library Operations
Turning the Library On and Off
2
25