Table of Contents
Advertisement
Initializing Nonvolatile Information
The library nonvolatile memory resides on the robotic controller card.
It retains library configuration information, calibration information,
and statistics. This information should be initialized only by an
authorized field service engineer when replacing the robotic controller
card.
The Service screen provides two commands involving information
stored in nonvolatile memory:
Initialize Nonvol Statistics—This command purges nonvolatile
•
memory of all statistical information about library operation. This
information is used to generate the library statistics report (see
"Generating Reports" on page 76).
Initialize Nonvol Config—This command returns library
•
configuration settings to the factory default condition, eliminating
current calibration data and any changes made using the
Configure Library and Configure Options commands.
ATL P1000 Series User's Guide
Chapter 5 Service Commands
Initializing Nonvolatile Information
5
81
Advertisement
Table of Contents
