Table of Contents
Advertisement
Procedure (continued)
Identify the source element (the element containing the cartridge
2
to be moved):
Press the appropriate element button (Storage Bin, Tape Drive,
a
Load Port, or Gripper).
The GUI displays a range of addresses in the Range box (below
the Destination box).
Using the keypad, enter the address of the source element.
b
If you make a mistake inputting the address, press the
backspace button to erase the entry character by character.
Press the Select button.
c
The Source box displays the source information and the
Destination box becomes active.
Identify the destination element:
3
Press the appropriate element button (Storage Bin, Tape Drive,
a
Load Port, or Gripper).
The GUI displays a range of addresses in the Range box (below
the Destination box).
Using the keypad, enter the address of the source element.
b
If you make a mistake inputting the address, press the
backspace button to erase the entry character by character.
The destination information appears in the Destination box as
you type.
Press the Execute button to initiate the move.
4
The GUI displays a "Command In Progress" screen. When the
move is complete, the "Command In Progress" screen disappears.
To cancel the move, press the Abort button on the screen.
Press the Back button to return to the Operator screen.
5
ATL P1000 Series User's Guide
Chapter 4 Operator Commands
Moving a Cartridge
65
Advertisement
Table of Contents
