Figure 58 Loosening The Inner Nuts - Quantum P1000 Series User Manual

Appendix B Installing the Slide Assembly in the Rack
Adjusting the Slide Assembly
Figure 58 Loosening the
Inner Nuts
106
Procedure
When the slide assembly tray is in the desired position, tighten all
3
inner nuts:
Extend the slide assembly out of the rack until both the
a
intermediate and inner channels of the slide rails lock (see
figure 57 on page 105).
This allows you to access the front screws.
Tighten each of the front nuts by holding the nut with an
b
11/32 inch open-ended wrench and then tightening its
corresponding screw with a Phillips screwdriver.
Press on the inner channel locks to release them (see figure 57
c
on page 105).
Push the slide assembly back into the rack until the access hole
d
on the outside of the inner channel exposes a screw.
Use a Phillips screwdriver to tighten the screw while holding
e
its corresponding nut with an 11/32 inch open-ended wrench.
Repeat steps 3d and 3e to tighten the remaining inner nuts.
f
Push the slide assembly tray back into the rack.
g
Check for adequate clearance. If necessary, repeat this procedure to
4
adjust the slide tray further.
ATL P1000 Series User's Guide
Inner nuts
Inner nuts