Start-Up Problems; Table 9 Start-Up Problems - Quantum P1000 Series User Manual

Chapter 6 Troubleshooting

Start-up Problems

Table 9 Start-up Problems

86
Start-up Problems
Table 9 provides corrective actions for problems which may occur
while starting up the library.
Problem
The library does not power
on.
The library or tape drives do
not respond on the SCSI bus.
The library reports are not
ready during initialization.
One or more tape drives fail
to spin up during start-up.
The gripper has a cartridge,
preventing system calibration
and inventory.
The library starts up in
standby mode.
ATL P1000 Series User's Guide
Corrective Action
Be sure the power switch is on and the
power cord is connected to a grounded
electrical outlet.
Be sure each SCSI device on the same
SCSI bus has a unique address, and that
the last device is properly terminated.
Determine the failure type by checking
any previous error codes returned to the
host computer. Correct the cause of the
error.
Check all SCSI cabling and termination on
the back panel of the library. If necessary,
contact your field service representative
about replacing the drive(s).
Manually remove the cartridge from the
gripper, and then restart the library.
Press the Standby button. Verify that the
library switches to on-line.
The setting of the Power-On option
determines whether the library will be
on-line or off-line when it is powered up.
To change this setting, see "Configuring
Library Options" on page 62.
6