Table of Contents
Advertisement
Figure 27 Typical
Two-Host SCSI
Configuration
Host connector
15 in. (38 cm)
SCSI cable
In the two-host configuration (see figure 27), host 1 is connected to the
library and daisy-chained to tape drives 0 and 1 (upper drives). Host 2
is connected to tape drive 3 and daisy-chained to tape drive 2 (lower
drives). The first SCSI bus is terminated at drive 0; the second is
terminated at drive 2.
For this configuration, you need the following items from the
accessories kit:
both 7-inch SCSI cables
•
•
15-inch SCSI cable
2 SCSI terminators
•
ATL P1000 Series User's Guide
Chapter 2 Installing the P1000 Library
Connecting Host Computers
P1000 back panel
Terminators
7 in. (18 cm)
SCSI cables
To host computers
37
Advertisement
Table of Contents
