Table of Contents
Advertisement
Adjusting the Slide
Assembly on the
Mounting Brackets
Figure 56 Loosening the
Outer Nuts
Adjusting the Slide Assembly
Now that the slide assembly is installed in the rack, verify that:
The front door of the rack opens and closes freely.
•
The rear door of the rack opens and closes freely.
•
When fully extended, the slide assembly extends at least 30 in.
•
(76.2 cm) from the front of the rack.
If the slide assembly and rack do not meet the above requirements,
complete the procedures in this section to adjust the slide assembly.
The number of adjustments required varies from rack to rack.
To adjust the slide assembly on the mounting brackets:
Procedure
B
Loosen the outer nuts on both sides of the slide assembly (see
1
figure 56).
These nuts secure the mounting brackets to the slide rails.
ATL P1000 Series User's Guide
Appendix B Installing the Slide Assembly in the Rack
Adjusting the Slide Assembly
Outer nuts
Outer nuts
B
103
Advertisement
Table of Contents
