Table of Contents
Advertisement
Chapter 2 Operating the Library
Operating Procedures
Placing the Library
2
Online
Taking the Library
2
Offline
Removing Power
2
from the Library
16
After several seconds, verify that SDA shows System On-line.
3
Note:
System On-line
up state is configured for
Off-line
To place the library online:
With the library power applied and the SDA showing
1
, press the control panel
Off-line
Verify that System On-line is displayed in the SDA.
2
To take the library offline:
With the library power applied and the SDA showing System
1
On-line, press the control panel
The library robotics will stop after completing the current
2
command(s). Verify that System Off-line is displayed in the
SDA.
To remove power from the library:
Press the control panel
1
will stop after completing the current command(s). Verify that
System Off-line is displayed in the SDA.
At the rear panel, set the AC power switch to the O (off)
2
position.
Always leave library power off for at least 15
Caution:
seconds before turning the power on again.
Quantum|ATL 7100 Series Library Operator's Guide
is only displayed if the library power-
On-line
is displayed.
STANDBY
STANDBY
button. The library robotics
STANDBY
. Otherwise,
System
System
button.
button.
Advertisement
Table of Contents
