Table of Contents
Advertisement
Chapter 4
Operator Commands
This chapter describes the commands on the Operator screen of the
touch screen graphical user interface (GUI). Using this screen, you can:
configure the library
•
configure library options
•
•
move a tape cartridge
inventory the tape cartridges
•
calibrate the library
•
•
exercise the library
unload a tape drive
•
unload the load port
•
The Operator screen is restricted to persons with Operator or Service
access privileges.
Note: The commands on the Operator screen are operational only when the
library is in Standby mode.
Note: This chapter assumes you are familiar with the P1000 GUI. If you are
not, see "Using the GUI" on page 42 for more information.
ATL P1000 Series User's Guide
Chapter 4 Operator Commands
4
57
Advertisement
Table of Contents
