Turning The Library On And Off; Turning On The Library; Placing The Library On-Line Or Off-Line; Turning Off The Library - Quantum P3000 Series User Manual

Turning the Library On and Off

Turning On the
2
Library
Placing the Library
2
On-line or Off-line
Turning Off the
2
Library
This section explains how to:
• Turn on the library
• Place the library on-line or off-line
• Turn off the library
• Test the installation
To turn on the library:
Verify that:
1
• Power cables are firmly in place
• All doors are closed
Turn on the power switch located behind the small sliding
2
door below the GUI.
After several seconds, verify that the current state of the library
3
("System On-line" or "System Off-line") appears in the System
State display on the GUI (see
With the library turned on, press the Standby button on the GUI.
Pressing the Standby button toggles the library between on-line
and off-line states.
To turn off the library:
Place the library off-line by pressing the Standby button.
1
The library robotics completes any current commands and then
stops.
Verify that the GUI display indicates "System Off-line."
2
Quantum|ATL P3000 Series User's Guide
Chapter 2 Basic Library Operations
Turning the Library On and Off
figure 12).
2
23