Table of Contents
Advertisement
Figure 18 Placing the
Library on the Slide
Assembly Tray
Screws
Procedure (continued)
Secure the library to the slide tray, using six screws from the
5
accessories kit (see figure 18).
Verify that, when the slide assembly is fully extended, there is
6
adequate clearance around the library to access the back panel and
remove the library enclosure.
Press on the inner channel locks to release them (see figure 18) and
7
then push the slide assembly all the way into the rack.
To prevent the library from sliding out of the rack during
8
operation, secure the locking brackets to the retma rails (see
figure 19 on page 26).
ATL P1000 Series User's Guide
Chapter 2 Installing the P1000 Library
Unpacking the P1000
Inner channel lock
25
Advertisement
Table of Contents
