Installing The Slide Assembly In The Rack - Quantum P1000 Series User Manual

Installing the Slide Assembly in the
Rack
To install the slide assembly in the rack (see figure 55 on page 102):
Procedure
Loosen (but do not remove) the nuts holding the rear mounting
1
brackets to the slide assembly.
Measure the depth of the rack, from the outside edge of the front
2
retma rail to the outside edge of the rear retma rail.
Adjust the rear mounting brackets so that the distance from the
3
front mounting brackets to the rear mounting brackets is slightly
greater than the depth of the rack.
Insert the slide assembly into the rack:
4
Lift the slide assembly and tilt it sideways.
a
Insert the back end of the slide assembly into the front of the
b
rack, keeping the slide assembly above the temporary support
screws.
When the rear brackets clear the rear retma rails, turn the slide
c
assembly right side up.
Place the slide assembly in the rack so that each bracket rests
d
on a temporary support screw.
Secure the front mounting brackets to the front retma rails, using
5
four screws from the accessories kit.
Adjust the rear mounting brackets so they are flush with the
6
outside of the rear retma rails.
Secure the rear mounting brackets to the rear retma rails, using
7
four screws from the accessories kit.
Note: Do not tighten the nuts securing the rear mounting brackets to
the slide assembly. You will tighten these during the following
procedure, "Adjusting the Slide Assembly."
Remove the four temporary support screws.
8
ATL P1000 Series User's Guide
Appendix B Installing the Slide Assembly in the Rack

Installing the Slide Assembly in the Rack

B
101