Table of Contents
Advertisement
Chapter 2 Installing the P1000 Library
Connecting Host Computers
Figure 26 Single-Host
SCSI Configuration
Host connector
15 in. (38 cm)
SCSI cable
Terminator
36
In the single-host configuration (see figure 26), the host computer is
connected to the host connector on the rear panel of the library. Since
there is only one SCSI bus, use all of the SCSI cables from the
accessories kit to daisy-chain the library to each of the tape drives.
ATL P1000 Series User's Guide
P1000 back panel
21 in. (53 cm)
SCSI cable
7 in. (18 cm)
SCSI cables
To host computer
Advertisement
Table of Contents
