Table of Contents
Advertisement
Figure 25 Correct Tape
Cartridge Orientation
Procedure (continued)
Remove the load and bulk packs from the library (see figure 20 on
2
page 28):
Grip the load pack handles and squeeze them together.
a
This releases the latches securing the load pack.
Still holding the load pack handles, pull the load pack forward
b
and out of the library.
Repeat steps 2a and 2b to remove the bulk pack.
c
Set both packs aside.
3
Reaching in through the front doors of the library, insert a tape
4
cartridge into each of the nine storage bins above the tape drives.
(See figure 25 for the correct tape cartridge orientation.)
Each cartridge should slide into place with very little force. If a
cartridge does not slide into place easily, check the cartridge for
correct orientation and structural integrity.
Insertion arrow
Bar code label
Write-protect switch
Insert a cartridge into each of the five storage bins above and
5
below the load port at the front of the library.
This requires you to reach into the library through the front doors
and then back toward the front. There are four bins above the load
port and one bin below.
Verify that each cartridge is properly seated in the bin (see
6
figure 25 for correct cartridge orientation).
ATL P1000 Series User's Guide
Chapter 2 Installing the P1000 Library
Preparing and Inserting Tape Cartridges
33
Advertisement
Table of Contents
